Provide customized design one-stop service
Nov. 21, 2026
Share:
A 25 cm² catalyst-coated membrane (CCM) and a 25 cm² porous transport layer (PTL) can have different shapes, edge details and alignment requirements. Before requesting samples for a PEM water electrolyzer, compare the coating boundary, PTL footprint and gasket opening on the same cell drawing.
Geometric active area is the reference area used to report the cell's current density. Ask the supplier or test lab how that area is defined for the specific hardware. The coated area is the region covered by catalyst on a membrane face. The membrane outline, PTL footprint and gasket opening are separate drawing dimensions. Each can have a different shape or size.

Figure 1. Illustrative overlay of component boundaries. Their relative positions and dimensions depend on the cell design.
Use one drawing origin and a consistent view for each side. Overlay the coating boundary, porous component outline and gasket opening. Check where each edge falls relative to the recess and sealing land. Confirm the anode and cathode orientations independently, because the two sides can use different shapes or materials.
Review the plan view together with a cross section. The plan view shows whether edges and cutouts register. The cross section shows how thickness, recess depth and the specified compression affect contact and sealing. See the CCM selection guide and titanium PTL selection guide for the material and interface details.
Area alone cannot establish fit. A 50 × 50 mm square and a 40 × 62.5 mm rectangle each cover 2,500 mm² (25 cm²). Their edges land in different positions even when their centers align. Check length, width, corners and tolerances before treating samples as interchangeable.

Figure 2. Equal geometric area with two different footprints. Example dimensions are illustrative.
| Item | Drawing details | Question to confirm |
|---|---|---|
| CCM coating | Coated length and width on each side, corner shape and coating location | Does the coating align with the intended working region on both faces? |
| Membrane outline | Overall dimensions, edge margin, cutouts and orientation | Does the membrane fit the drawing and reach the specified sealing land? |
| PTL footprint | Length, width, corner radius, orientation and thickness tolerance | Does the PTL fit the recess and meet the specified contact and compression conditions? |
| Gasket opening | Inner and outer outline, sealing land and gasket thickness | Does the opening clear the specified parts and leave the designed sealing surface? |
| Alignment and area basis | Common datum, registration tolerance and area used for current density | Are the drawings referenced to the same origin, and is the test area stated explicitly? |
When comparing polarization curves, ask how the geometric area was defined and how the cell was assembled and tested. Record the test hardware and conditions alongside each curve. See the published PEM water electrolysis reference protocol for an example of documented hardware and test methods.
Drawing revision, units, anode and cathode orientation, and a shared alignment datum.
Nominal cell active area and how the drawing or test report defines it.
CCM outline, separate coating boundaries, PTL dimensions and gasket opening.
Relevant tolerances, recess depth and your assembly's specified compression conditions.
Which components you need, quantity and the documentation needed for sample approval.
They may coincide in a given design. Ask which boundary the drawing uses and which area the test report uses to calculate current density.
Request the coating location, cutouts, corner details and alignment tolerances as well. For fit approval, compare the correct revision of the cell drawing.
The required clearance and overlap depend on the recess and sealing design. Confirm both outlines and the specified assembly conditions with the cell designer.
Share your drawing, area definition and sample requirements so Gitan can review the dimensions with you. Contact Gitan about your CCM project.
Need Custom Design and Development for CCM And PEM Electrolyzers?
We strongly support customer personalisation and customisation, providing the most suitable solutions based on different customer needs. If you have any customisation requirements, please contact us and we will provide you with the most professional advice and products.
View MoreRelated Products
We R&D, design, manufacturing and sales of PEM membrane electrodes, hydrogen and oxygen electrolytic cells and other ancillary products.